h. Follow the on screen prompts. With the volume set to 85, select “Auto level & polarity test left channel.”
i. If you receive a message that the levels are too low, first check that both ends of the mic cable are firmly docked and repeat the test.
Increase volume if necessary.
j. After completing the left measurements, move the microphone to the right speaker, keep the volume the same, and repeat step i for the
right speaker
Note: this process can take about 5 minutes per channel while Wavelet calculates the settings. Once they are set, Wavelet remebers the
settings even after power down, so you do not have to repeat this process.
k. You can view the results by clicking “Level & polarity results”. You have now completed the channel level setup and phase test and can
continue with room correction.
-Settings
-Setup
-Proceed
-Channel levels & driver polarity tests
To Next Page
Loading...
