Need help?Do you have a question about the Legacy LA 160 and is the answer not in the manual?
Indicates when the remote on system is energized.
Adjust high impedance input gain for best matching with PREAMP output.
Connects to units with BTL circuitry or common-ground types using speaker outputs.
Uses gold plated RCA jacks for high impedance, requires Y-adaptor for 2 channel outputs.
Protects amplifier and electrical system from wrong electrical conditions.
Connects the +12V DC power supply wire using lugs and screws.
Connect +12VDC power supply wire to the (+) terminal of the battery.
Connects the ground wire from the chassis of the automobile.
Connects control wire for remote turn-on/off via power antenna wire.
Connects speakers (4 to 8 ohms) to signal barrier strip.
Details for connecting car stereo outputs to the amplifier inputs.
Describes connecting the amplifier via RCA jacks to the car stereo.
Covers connecting via high-level speaker outputs for BTL or common ground.
Wiring for a car stereo with four speaker outputs.
Specific wiring for floating ground in four speaker mode.
Specific wiring for common ground in four speaker mode.
Wiring for a car stereo with two speaker outputs.
Specific wiring for floating ground in two speaker mode.
Specific wiring for common ground in two speaker mode.
Connects speaker output terminals to corresponding speakers, notes on wire quality.
Details on connecting the main power lead, ground, and remote switch.
Connects the +12V power supply directly to the battery positive terminal.
Connects the ground pole to the negative battery terminal or car chassis.
Connects the remote pole to an external switch for positive 12V ON/OFF.
Steps for testing the amplifier after connection, including checking for noises and adjusting gain.
Technical details of the amplifier, including output power, frequency response, and impedance.
General| Brand | Legacy |
|---|---|
| Model | LA 160 |
| Category | Car Amplifier |
| Language | English |
To Next Page
