To Next PageTo Next PageWhy is it difficult to assemble the barrel to the head of Legacy Tools?
If assembling the barrel to the head seems difficult or springy, it could be due to several reasons: * The grease cartridge may not be completely inserted into the barrel. Always push the Lock-n-Load™ switch forward as far as possible. * There may be excess grease in the head. Remove the excess grease (RP009001). * The auto bleeder might be plugged (RP009006L).
What to do if no air is heard passing through auto bleeder when removing or installing barrel on Legacy Lock-n-Load L1175L?
If no air is heard passing through the auto bleeder when removing or installing the barrel: * Repeat the process until the auto bleeder is cleared. * Contact Legacy Manufacturing.
Pull follower rod from barrel and lock it into place before disengaging the barrel.
Position gun, hold head, and connect barrel by pushing into head and engaging switch.
Explains how the automatic bleeder expels air during barrel reconnection.
Step-by-step guide on safely removing the barrel for refilling the grease gun.
Step-by-step guide on safely re-installing the barrel after refilling.
Ensure follower rod is locked and cartridge is fully seated.
Steps to bulk fill the grease gun, including air extraction.
How to prime the grease gun after refilling a cartridge.
Procedure for loading grease using a manual filler pump.
Steps for loading grease via suction, including barrel and follower rod handling.
Steps to troubleshoot if air is not heard passing through the auto bleeder.
Common reasons and solutions when assembling the barrel to the head is difficult.
Troubleshooting steps when grease does not flow when the handle is stroked.
General
