5
D. Processor: Signal input and output connections for a audio
processor (surround sound processor, equalizer, etc.)
E. Main Outputs
F. Balanced Outputs: Signal output to your amplifier is made through
two gold plated RCA (unbalanced) type connectors and two XLR
(balanced) type connectors. The XLR pin configuration is as
follows: ground is pin 1, positive is pin 2, and negative is pin 3.
G. AC Line Input: Insert the power cord into the AC receptacle and
then connect it to an appropriate power source. The fuse can be
removed by pulling the fuse drawer out and clipping in a new one.
Once all connections are made the power switch may be set to the
on position. The Streamline may be left on as it draws a negligible
amount of power. NOTE: The AC line voltage is preset at the
factory but may be changed upon your request.
To Next Page
Loading...
Need help?
General
