Repeat symm at the right.
Put a 4x2 ver to the left.
Repeat symm at the left.
Put a ridged 2x1 hor at the front edge, in the middle, the hor
ridges to the front.
Repeat symm at the back.
Number 4.
Insert a #6 ribbed stick into the second hole from the left,
overhanging to the front and to the back.
Repeat symm at the right.
Put two front wheels on, the rubberized rims to the to the front.
.
Repeat symm at the back.
Number 5.
Put four F 2x1 hor on the four corners.
Number 6.
Put a 10-button long chain piece hor, the two FS 2x1 ends to the
back, the 1x1 cylinder with a hat to the bottom, on the front
edge and overhanging to the front, the two FS 2x1 ends on the
left and right corners.
Repeat symm at the back.
Number 7.
Put a FS 6x4 with an attached connector hor on top, in the
middle.
Flip upside down and install at the left side of your structure,
inserting the attached connector into the 5th hole from the left,
in the third row. Lay aside.
Bag 27. Make an underside tip part.
Number 1-2.
Put a F 3x1 hor on the table. Put a F 2x1 with a cornice hor on
top, on the right end, the cornice to the front.
Put a F 1x1 to the left.
Put a F 3x1 hor on top and to the right.
To Next Page
Loading...
