Put a Fs 4x1 hor on top of the two left columns, overhanging to
the left.
Put an 8x6 end piece hor on the table, the slide to the left, and
install your part as is on the second row from the back, putting
the overhanging left end on the two buttons there. LMA.
Number 3.
Put a F 3x1 hor on the table. Put a F 2x1 with a cornice hor on
top, on the right end. The cornice to the back.
Put a F 1x1 to the left. Put a F 3x1 hor on top and to the right.
Put a FS 4x1 hor on top of the two left columns, overhanging to
the left.
Install as is on the second row from the front, symm to the
similar piece at the back.
Number 4.
Put a 2x1 slide hor on the right end of the front edge, the slide
to the right.
Repeat symm at the back.
Put a 4x1 ver between the two PPs, on the second column from the
right.
Put a 2x1 slide hor on the front edge, to the left of the 2x1
slide already there, slide to the left.
Repeat symm at the back.
Put a FS 4x1 hor to the front and to the left.
Repeat symm at the front.
Put a FS 2x1 ver between the leftmost columns of the two PPs.
Put a grate ver to the right.
Install this part as is on the left end of your structure (still
upside down), inserting the cornices from the left into the
railings at the top of your structure. LMA.
Bag 28. Bags 28-29 finish the underside tip.
Make a part.
Number 1.
Put a F 4x2 (gray) ver on the table.
To Next Page
Loading...
