Make a part. Stack two F 1x1 pieces. Put them underneath the 2x1
hammer piece. Put a FS 1x1 on top. Put this piece sideways on the
table, the curve on the left to the front. Put a 2x1/2x1 corner
piece ver, the side buttons to the left, to the right of your
part, and connect them.
Install as is on the 6th-8th columns from the left, on the second
and third rows from the back. LMA.
Bag 5.
Make a part. Put a 2x1/2x1 corner piece ver on the table, the
side buttons to the right. Mount a bench piece ver on the side
buttons, the smooth wall to the right and to the top. Install as
is on top of the previous part and overhanging to the right.
Put a FS 2x1 ver on the 13th column from the left, on the second
and third rows from the back.
Skip two columns to the right and put a FS 2x1 ver there.
Skip two columns to the right and put a bench ver there, the seat
to the left.
Skip three columns to the right and put a bench ver there, the
seat to the left.
Put a ridged 2x1 ver to the right, the vertical ridges to the
left.
Bag 6.
Put a F 4x2 ver on the left edge, in the middle, overhanging to
the left.
Put a bench hor to the right, on the second row from the back,
the seat to the back.
Put a 3x1 lip ver to the right and to the front, the lip to the
front.
Put a 2x1/2x1 corner piece hor on the 7th and 8th columns from
the left, on the third row from the front, the side buttons to
the front.
Put a FS 2x1 hor on top.
Bag 7.
Put a 2x1 hor on the back row of the F 4x2 on the left edge.
Repeat symm at the front.
Put a 6x1 hor on the left end of the front edge.
Put a 6x1 hor to the right.
To Next Page
Loading...
