part.
Book 2.
Bag 1.
Put a 28x6 with two holes hor on the table.
Put a FS 3x1 hor on the right end of the front edge.
Repeat symm at the back.
Bag 2.
Go to the back edge and put a 4x1 hor to the left.
Put a 6x1 hor to the left.
Put a ridged 2x1 hor to the left, vertical ridges to the front.
Put a 1x1 to the left.
Put a 6x1 hor to the left.
Repeat.
Put a F 4x4 on the right edge, in the middle, on the three
rightmost columns, overhanging to the right.
Bag 3.
Put a 1x1 with a handle on top, in the right front corner of the
PP, the handle to the front.
Put a 1x1 to the left.
Repeat steps 1-2 symm at the back.
Put a FS 2x1 ver on the 7th column from the left, on the second
and third rows from the back.
Put a F 1x1 to the front.
Put a F 3x1 ver to the right and to the back.
Skip two columns to the right and put a F 12x2 hor on the second
and third rows from the back.
Put a F 2x2 disk to the right.
Bag 4.
Put a 1x1/1x1 corner piece on top of the F 12x2, on its third
column from the right, on its front row, the hole side to the
bottom and the button side to the front and to the top. LMA.
To Next Page
Loading...
