Put a F three-button corner piece on the table, to the left of
your part, letter j.
Connect it by putting another such piece, letter j, on top of the
dot five and on top of the left edge of your main part.
Put a S 4x1 curve hor, slide to the left, on the front edge, on
the two leftmost columns and to the left.
Put a S 4x1 curve from a sep bag hor to the back and to the
right.
Install upright, hor, the curves to the front at the left, on the
front edge of your main part. LMA.
Number 9. Make a part.
Put a F 6x2 hor on the table. Put a F 2x1 ver on the right edge.
Put a F 4x2 hor to the left.
Put a F three-button corner piece on the table, to the left of
your part, letter D (1-4-5).
Connect it by putting another such piece, letter D, on top of the
dot four and on top of the left edge of your main part.
Put a S 4x1 curve from a sep bag hor, slide to the left, on the
front edge, on the two leftmost columns and to the left.
Put a S 4x1 curve hor to the back and to the left.
Install symm at the back. Put a fs4x1 hor on the front upright
to the right of the upper s curve. Put a fs6x1 hor below it, then
put a fs1x1 on the upper-right corner. Repeat symm at the back.
LMA.
Number 10. Make a part.
Put an 8x6 end piece hor on the table, the slide to the left.
Put another such piece the same way on the top, skipping two
leftmost columns.
Put a 1x1 underneath the protruding front edge, on the second
column from the right.
Repeat symm at the back.
Install as is on top of your main part, skipping the leftmost
column and overhanging one column to the right.
Number 11.
Flip your part upside down. Put a 4x1 with side railings hor,
To Next Page
Loading...
