clasp to the right, LMA.
Number 5. Make the tip of the train part.
Put a 2x2 slide hor on the table, the slide to the front.
Put a 4x1 receiver piece hor on top and to the sides.
Make two stacks of two F 1x1 pieces and put underneath the sides
of the PP.
Affix a sticker (a black strip) on top of the receiver piece.
Install sideways, ver, the receiver and slide to the left, on the
left edge of your main part, on the four side buttons there. LMA.
Number 6.
Make a part. Put a 1x1 with a side button on the table, the side
button to the left. Mount a 1x1 wedge from a sep bag
(transparent) on the side button, the slide to the top.
Repeat to make two.
Put one, as is, on the front edge, skipping one column from the
left (not counting the receiver).
Repeat symm at the back.
Skip two columns to the right and put a 2x1 with the side buttons
hor there, the side buttons to the front.
Repeat at the front (the side buttons to the front).
Skip one column to the right and put a 1x1 wedge on the second
row from the front, the slide to the right.
Put a 1x1 wedge to the back, the slide to the right. LMA.
Number 7.
Make a part. Put a F 4x1 hor on the table. Put a FS 4x2 hor on
top and overhanging to the front.
Put a F 2x1 with a handle hor underneath the overhanging end, in
the middle, the handle to the front. Affix a sticker (with the
gauges and levers) on top. Install diagonally, hor, the sticker
to the right, to the left of the seat, inserting the handle into
the two clasps there. Lay aside.
Number 8. Make a part.
Put a F 6x2 hor on the table. Put a F 2x1 ver on top, on the
right edge.
Put a F 4x2 hor to the left.
To Next Page
Loading...
