Need help?Do you have a question about the LEGRAND The Radiant Collection and is the answer not in the manual?
Ensure the power to the device is off at the circuit breaker before starting the installation.
Identify and disconnect the wires (HOT, LOAD, NEUTRAL, GROUND, TRAVELER) from the old switch.
Connect the smart switch wires (WHITE, LOAD, HOT, GREEN, YELLOW) using provided wire nuts.
Gently fold wires into the electrical box and secure the switch using device screws.
Restore power at the circuit breaker and test the switch operation by pressing the paddle.
Align sub-plate, secure with screws, then angle and snap the screwless wall plate into place.
Download the app, connect the switch to your network via the app instructions, and control it.
Use the top to turn on, bottom to turn off. Hold 'off' for 10s for factory reset.
Shows device status. Refer to 'LED Locator Light Explanations' for detailed meanings.
Details FCC compliance, potential interference, and testing limits for Class B digital devices.
Specifies compliance with FCC radiation exposure limits and minimum separation distances.
States compliance with Industry Canada RSS-102 for RF exposure and notes on modifications.
To Next Page
General