Need help?Do you have a question about the Lehle Little Dual II and is the answer not in the manual?
General| Type | ABY Switcher |
|---|---|
| Inputs | 2 |
| Outputs | 2 |
| Input Impedance | 1 MΩ |
| Channels | 2 |
| Power Supply | 9V DC |
| Output Impedance | 1 kΩ |
| Switching | Relay |
Distributes stereo or dual-mono signals via a TRS jack to outputs A and B.
Connects instruments or effects units for mono or stereo signals to outputs.
Connects a second pickup or stereo output, routing signals to output A.
Connects an amplifier or mixing desk; grounds the instrument via this socket.
Inverts the phase of the signal from output A by 180° to prevent phase cancellations.
Connects an amplifier or mixing desk; isolated by Transformer HZ for hum-free operation.
Connects grounds of output sockets A and B to minimize noise.
Specifies the required voltage (9-15V) and recommends isolated power supplies for noise reduction.
Explains the meaning of LED colors (Green for A, Red for B) indicating active outputs.
Details the microcontroller-controlled true-bypass relay circuit with pop suppression.
Explains how to mount the device on a pedalboard using screws or optional kits.
Setup for using stereo effects with two amps, one for left, one for right signal.
Configures one amp for dry signal and another for wet effects.
Routes separate piezo and magnetic pickup signals to two different amplifiers.
Routes piezo signal to a mixer and magnetic pickup to an amp.
Uses the pedal to mute the signal for tuning, isolating the tuner from the signal path.
To Next Page
