Why is there no display on my LEHNER Spreader?
If your LEHNER Spreader's operating panel shows no display, it may be because the + and - were switched, or the fuse is defective. Unplug the operating panel and correct these errors, as the device has reverse voltage protection.
Why agitator does not turn in my LEHNER Spreader?
If the agitator of your LEHNER Spreader does not turn, it may be due to the agitator motor consuming too much power. To resolve this, empty the hopper.
How to fix spreading disc if it does not reach set speed in LEHNER Spreader?
If the spreading disc of your LEHNER Spreader is not reaching the set speed, it could be due to excess load or a motor bearing that is not running smoothly. Check the motor for ease of movement to resolve this issue.
What to do if slide jams in my LEHNER Spreader?
If the slide of your LEHNER Spreader jams, it's likely that spreading material or dirt has become jammed in the slide. Check the slide for any foreign bodies and clean it.
Why does the operating panel crackle on my LEHNER Spreader?
If the operating panel of your LEHNER Spreader crackles, it is likely due to a loose contact on the power supply. Check the contacts and fuses to resolve this issue.
What to do if the display shows ERR on my LEHNER Spreader?
If the display of your LEHNER Spreader shows 'ERR', several issues could be the cause: * The spreading disc may not be turning. In this case, you should check the spreading disc. * The agitator might not be turning. Check the agitator and restart the spreader if needed. * The material might be too compacted, or the control panel plug may not be properly connected to the spreader. Inspect the plug connections and lines for damage. * A sensor could be damaged, requiring a replacement. * Magnets on the spreading disc might be missing (there should be 8). Attach magnets or consider replacing the spreading disc. * There could be a poor plug connection for the operating panel. Clean the contacts on the 20-pin plug. * The drive motor may not be reaching speed or starting up. Check ...
Explains warning symbols and their meanings.
General safety precautions for operating the device.
Instructions for mounting the spreader frame.
Steps for attaching the hopper to the frame.
Details on connecting the device electrically.
Identifies and explains controls on the operating panel.
How to turn the main components on and off.
Adjusting the rotational speed of the spreading disc.
General| Spreading width | 1 - 6 m |
|---|---|
| Working width | 1 - 6 m |
| Hopper capacity | 110 l |
| Drive type | Electric |
| Material | Polyethylene |
To Next Page
