Why is there no display on my LEHNER Spreader?
If your LEHNER Spreader's operating panel shows no display, it may be because the + and - were switched, or the fuse is defective. Unplug the operating panel and correct these errors, as the device has reverse voltage protection.
Why agitator does not turn in my LEHNER Spreader?
If the agitator of your LEHNER Spreader does not turn, it may be due to the agitator motor consuming too much power. To resolve this, empty the hopper.
How to fix spreading disc if it does not reach set speed in LEHNER Spreader?
If the spreading disc of your LEHNER Spreader is not reaching the set speed, it could be due to excess load or a motor bearing that is not running smoothly. Check the motor for ease of movement to resolve this issue.
What to do if slide jams in my LEHNER Spreader?
If the slide of your LEHNER Spreader jams, it's likely that spreading material or dirt has become jammed in the slide. Check the slide for any foreign bodies and clean it.
General| Spreading width | 1 - 6 m |
|---|---|
| Working width | 1 - 6 m |
| Hopper capacity | 110 l |
| Drive type | Electric |
| Material | Polyethylene |
To Next Page
