Leica iCON gps 60 Setup

Leica iCON GPS 60 Base Setup
This is to setup the
Leica
iCON
GPS
60
as a BASE receiver transmitting base correction through its COM port (P1).
Although this setup is generic, this is mainly used in conjunction with a senseFly eBee RTK system. The iCON GPS 60
will be directly plugged into the flight control/monitoring computer for the eBee RTK system. For specific setup on
the eBee and computer, please refer to relevant reference documents/manuals.
Step
Screen Menu
Instructions
Visual
1
.
Main Screen
Setting Up the Equipment
• Set up the tripod, mount and level the tribrach onto the
tripod.
• Check that the tribrach is correctly centred over the
marker.
• Take the GEV269 cable from Port 1 and connect to
computer’s USB port.
• Turn on the antenna and make sure the receiver is in a
relative open area and is tracking satellites.
2
Settings >>
Tools
Base Setup
• Access the wizard via Settings > Tools > Base Setup.
In the Position screen highlight Modify and press
The instrument can be manually set up as a stand-alone
base station with in three different ways using the Base
Setup wizard:
• Get here:
Instrument determines position and uses current position
as a new base point.
• Edit:
Manual input of coordinates to generate a new base
point.
• Find nearest:
Searches through the Base Point List for a known base
point within a radius of 20 m of the current instrument
position.
Base Setup :
Position
For most case:
In the Position screen highlight Modify and press If
the base point is unknown, select Get here and press to
confirm (See above for options)

Leica iCON gps 60 Specifications

General

Brand	Leica
Model	iCON gps 60
Category	Measuring Instruments
Language	English