Leica S3 - Display Information and Indicators

EN
12
Displays
DISPLAYS
VIEWFINDER
1 2 3 5 6 97 8 1210 114
1
Horizon
(Tilt along the longitudinal axis/transverse axis; displays are
provided as an example of tilting in a clockwise direction; other
directions are displayed similarly)
– max. ±0.5°
– 0.5-2.5°
– 2.5-5°
– 5-10°
– flashing ≥10°
2
Shutter speed
– manually set value at /
– automatically controlled value at /
– (high) overexposure at , , or due to flash
– (low) underexposure at , , or due to flash,
undercutting of measuring range
– Long-term exposure (B setting)
– Memory card full warning
3
Exposure mode
– Automatic program
– Aperture priority
– Shutter priority mode
– Manual settings for shutter speed and aperture
4
Aperture
– manually set value at /
– automatically controlled value at /
5
Flash display
– Continuously lit: Flash ready
– Flashing: Flash loading, flash not ready
6
Light balance
(Markings: 1⁄2EV increment each, last markings/digits flash at ≤
-3EV/≥ +3EV) to show
– manual exposure balance
– Deviation of the current measurement to the saved exposure
setting (with metering memory lock in the automatic exposure
modes , , )
– Exposure compensation
7
Flash display
Illuminated = shutter speed ≤ sync speed set
8
Focus displays
– only appears in manual mode or for manual AF override:
continuously lit if setting is too large
– in manual mode: continuously lit if the setting is correct
– for AFsAFs: continuously lit if the setting is correct; flashes if
no correct setting is possible
– for AFcAFc: continuously lit if the setting is correct; goes out
when focusing restarts
– only appears in manual mode or for manual AF override:
continuously lit if setting is too short
9 Exposure compensation/flash exposure compensation set
10
Exposure metering method
– Multi-field metering
– Center-weighted metering
– Spot metering
11
Picture counter
– Total remaining number of pictures
– External memory
– (flashing at 2Hz) = memory card full
– (flashing at 2Hz) = no memory card inserted
– Maximum number in a picture series (L 14)
– Error message
12
ISO sensitivity
– manual setting
– automatic setting
– HI 1 HI 1 (ISO3200)/HI 2HI 2 (ISO6400)/HI 3HI 3 (ISO12500)/HI 4HI 4
(ISO25000)/HI 5HI 5 (ISO50000) = currently set sensitivity
Note
The viewfinder LCD is always lit when the camera is switched on. The
light level automatically adjusts to ambient brightness for reasons of
legibility.