Leica T-Scan 5 - Orientation Parameters, Reflectors, and LEDs; Measurement Mode Requirements

Starting the data recording
1. Switch on the Absolute Tracker system, the T‑Scan controller and the
application computer.
2. Start the application on the application computer and connect to the
T‑Scan system.
3. Initialise the Absolute Tracker.
4. To start data recording, hold down the trigger button on the handle of
the T‑Scan sensor. As long as the trigger button is held down, the data
is recorded.
5. To stop data recording, release the trigger button.
23 Operation