Lelit William - PL72 - Check the Functioning; Grind the Coffee

Lelit Espresso - English
EN
11
D
Check the functioning
Note. anks to the pre-set parameters, the grinder is immediately ready to grind
your coee.
D.1 Position the lterholder, with the correct lter inserted, on the fork (8) to
“hook” it with the pin (11).
Note. In the case you can’t insert your lterholder on the fork (8), you can change
the position of the upper lterholder pin (11), loosening it with a screwdriver to li or
lower it. Once you found the optimal position, screw the pin back (11) to grant a secure
support for your lterholder.
D.2 To grind 1 dose, press once the grinding switch (7) (PUSH), the LCC (9)
display will show in sequence the image referring to the dose per 1 coffee, the
grinding time programmed and the image of the grinder in action.
D.3 To grind 2 doses, press twice the grinding switch (7) (PUSH). The 2 presses
have to be within 2 seconds. The LCC (9) display will show in sequence the im-
age referring to the dose per 2 coffees, the grinding time programmed and the
image of the grinder in action.
E
Grind the coffee
Note. e grinder has been equipped with 64 mm at mills, that grant a uniform
and professional grinding.
E.1 Check that the hopper is lled with beans and that it has the cover (1).
E.2 Turn the grinder on by pressing the on/off switch (5). The stand-by led light
(6) will blink for a short time, the LCC display (9) will show the grinder icon con-
rming the turning on.
E.3 Position the lterholder, with the correct lter inserted, on the fork (8) to
“hook” it with the pin (11).
E.4 To grind 1 dose, press once the grinding switch (7) (PUSH), the LCC (9)
display will show in sequence the image referring to the dose per 1 coffee, the
grinding time programmed and the image of the grinder in action.
The grinder grinds the dose according to the set time. Wait until the grinding
is over, the message “OK” and then the grinder icon will appear on the LCC (9)
display. Remove the lterholder from the fork (8).
E.5 To grind 2 doses, press twice the grinding switch (7) (PUSH). The 2 presses
have to be within 2 seconds, the LCC (9) display will show in sequence the im-