Why is the long end of twine frayed with twine fibres left in the twine holder of my LELY WELGER Accessories?
If the long end of the twine is frayed and twine fibres are left in the twine holder, it might be because: * Spring “f" too highly tensioned: Loosen screw "g". adjust measurement “E".
What causes a twisting lock too short and torn open on my LELY WELGER Accessories?
If the twisting lock is too short and torn open, it may be because: * Wire rusty or unoiled: Free twister hook immerse coils in oil, store well oiled.
General| Brand | LELY WELGER |
|---|---|
| Model | AP 630 |
| Category | Accessories |
| Language | English |
Emphasizes operator responsibility for safe operation and maintenance.
Explains the meaning of Danger, Warning, Caution, and Note signal icons.
General safety guidelines: read manual, use guards, wear protective gear.
Pre-operation checks, safety distances, and procedures for clearing blockages.
Steps for safely parking the baler, including using wheel chocks.
Guides on adjusting drive shaft length for proper overlap and safety.
Steps for safely connecting the baler to the tractor, including drawbar and safety chain.
Procedures for safely disconnecting the baler from the tractor.
Table listing common faults, causes, and remedies.
Critical safety rules for maintenance, adjustment, and repair work.
Schedules for maintenance based on working hours (20, 50, 100, 500 hours).
Steps for draining, refilling, and checking transmission oil.
Procedures for installing/regrinding knives and adjusting ram slide rails.
Steps for timing the packer relative to the ram for precise operation.
Specific timing procedure for the cross-feeder on AP 530 models.
Specific timing procedure for the cross-feeder on AP 630 and AP 730 models.
To Next Page
