Why is the long end of twine frayed with twine fibres left in the twine holder of my LELY WELGER Accessories?
If the long end of the twine is frayed and twine fibres are left in the twine holder, it might be because: * Spring “f" too highly tensioned: Loosen screw "g". adjust measurement “E".
What causes a twisting lock too short and torn open on my LELY WELGER Accessories?
If the twisting lock is too short and torn open, it may be because: * Wire rusty or unoiled: Free twister hook immerse coils in oil, store well oiled.
General| Brand | LELY WELGER |
|---|---|
| Model | P23 |
| Category | Accessories |
| Language | English |
Emphasizes operator responsibility for safe machine operation and maintenance.
Explains the meaning of danger, warning, caution, and note symbols used.
Fundamental safety rules for operating and maintaining the baler.
Crucial safety precautions to observe during machine operation.
Explains the meaning and purpose of each safety decal.
Identifies safe operator zones and danger areas during operation.
Procedures for safely starting and preparing the baler for use.
Step-by-step guide for attaching and detaching the baler.
Instructions for connecting hydraulic hoses to the tractor.
Safe steps to follow when stopping the machine.
General operating guidelines for field use.
Procedure for adjusting the firmness of the bales.
Method for adjusting the length of the produced bales.
Steps to safely resolve material blockages in the baler.
Procedures for setting the timing of the packer and ram.
Ensuring correct timing for baler components.
Checking the dual clutch system and its torque settings.
Procedures for maintaining and adjusting the knotter.
To Next Page
