3 TRANSPORT
The CENTERLINER spreader can be transported in the
tractor’s 3 point lift.
- Apply all such lighting and warning signals as are
mandatory by law.
- For transport on public roads care should be taken that the
front axle pressure is sufficient (fit front weights, if
necessary) and that the maximum rear axle pressure is not
exceeded.
The tractor is easier to control when the CENTERLINER
spreader’s hopper is empty. It is therefore recommended to
fill the hopper after arrival on the plot to be worked. This also
eliminates the kind of fertilizer compression that may occur
during transport.
It is possible to couple a trailed carriage to the CENTER-
LINER spreader’s chassis (fig. 8). In case of such an
attachment, the (total) weights allowed by law as a maximum
and further regulations should be taken into account.
Make sure never to couple a trailed carriage to the rear of the
CENTERLINER spreader when working with the CENTER-
MATIC weighing element! Horizontal load on the weighing
element may cause a permanent inaccuracy.
43
8
To Next Page