LEM 1182 - Troubleshooting; Appliance Stops Running; Cleaning and Maintenance; How to Clean Your Grinder

CAUTION
Before cleaning, assembling or disassembling meat grinder, make sure the
grinder motor is OFF and the plug is removed from the outlet/power source.
CAUTION
Before using the device for the rst time please make sure to read carefully and
thoroughly through these operating instructions and the safety advice. Familiarize
yourself completely with the functions of the appliance.
GRINDER FEATURES
CLEANING AND MAINTENANCE
LEM Products • West Chester, OH 45011 • PH: 1-877-536-7763 • lemproducts.com LEM Products • West Chester, OH 45011 • PH: 1-877-536-7763 • lemproducts.com
6 3
How to clean your grinder
Meat remaining in the grinder head may be moved through by passing a slice of bread through the grinder head.
1. Before cleaning your grinder, switch the appliance o and unplug from electrical outlet.
2. Remove the meat stomper and meat tray.
3. Press the release button and turn the grinder head in a clockwise direction.
4. Unscrew the retaining ring and remove all parts from the grinder head. Hand wash in warm soapy water.
Grinder parts are NOT DISHWASHER SAFE. CLEAN IMMEDIATELY AFTER USE.
5. Rinse with clear hot soapy water and hand-dry IMMEDIATELY. DO NOT SOAK. NOT DISHWASHER SAFE
(discoloration may occur).
6. We advise you to lubricate the knife and the grinding plates with silicone spray (available at LEM Products).
WARNING!
Always be as thorough as possible when cleaning and sanitizing components.
Any parts exposed to raw meat may harbor or develop
bacteria possibly causing illness or death.
CAUTION
Cuts, injuries and/or re may result from non-compliance with all
operating procedures described within this instruction manual.
TROUBLESHOOTING
* This grinder comes with a Circuit Breaker Button, located on the bottom
next to the cord maintenance compartment.
A. Fine Plate
B. Medium Plate
C. Auger
D. Knife
E. Course Plate
F. Retaining Ring
G. Stung Plate
H. Stung Tube
I. Meat Stomper
J. Meat Pan
K. Head
L. Release Button
M. Main Housing
N. On/O/Reverse Knob
O. Auger Drive Gear Kit
P. Storage Drawer
If your appliance suddenly stops running
1. Turn Power Knob to OFF.
2. Unplug from electrical outlet.
3. Let the appliance cool down for 60 minutes.
4. Press the circuit breaker button at the bottom of the appliance.
5. Plug into electrical outlet.
6. Turn Power Knob to ON position.
Please contact LEM Products if the circuit breaker is activated too often.
F