ITEM DESCRIPITION
Motor 230V, 50Hz, 800W, 1400min
-1
Belt Size 152x1219mm
Disc Size 254mm
Disc Worktable Tilt 0-45
o
Belt Tilt 0-90
o
Disc Speed 1400min
-1
Belt Speed 517m/min
Weight 47kg
Noise emission:
The sound pressure level(unloaded): 78dB(A)
The sound pressure level(loaded): 84.2dB(A)
As with all power tools there is a certain amount of hazard involved with the operator and his use of the tool. Using the tool
with respect and caution demanded as far as safety precautions are concerned will considerably lessen the possibility of
personal injury. However, if normal safety precautions are overlooked or completely ignored, personal injury to the operator
can develop.
There are also certain applications for which this tool was designed. We strongly recommend that this tool NOT be modified
and/or used for any application other than for which it was designed. If you have any questions relative to its application DO
NOT use the tool until
y
ou have written to us and we have advised you.
Warning! For your safety
The machine shall be disconnected from the supply before maintenance.
Read and understand Owner’s Manual before using this machine.
Always disconnect from power when adjusting and service this machine.
Check that all guards are in place and secure locked before switching this machine on.
Do not wear gloves, neckties or loosen clothing. Tie back long hair.
Always wear safety goggle and ear protection
1, KNOW YOUR POWER TOOL. Read the owner’s manual
carefully. Learn the tools applications and limitations, as well
as the specific potential hazards peculiar to it.
2, KEEP GUARDS IN PLACE and in working order.
3, GROUND ALL TOOLS. If tool is equipped with
three-prong plug, it should be plugged into a three-hole
electrical receptacle. If an adapter is used to accommodate a
two-prong receptacle, the adapter lug must be attached to a
known ground. Never remove the third prong.
4, REMOVE ADJUSTING KEYS AND WRENCHES. Form
habit of checking to see that keys and adjusting wrenches
are removed from tool turning it on.
5, KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
6, AVOID DANGEROUS ENVIRONMENT. Don’t use power
tools in damp or wet locations. Keep your work area well
illuminated.
Read all these instructions before attempting to operate this machine and save these instructions.
SPECIFICATION
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS
1
To Next Page
Loading...
