6
1)In FM mode, DR2 will tune to the start of the available FM range
(87.50MHz) or the last FM station listed.
2)To manually change the FM frequency, Press the TUNE+/TUNE-
button to change the frequency by 0.1MHz.
4. ALARM: Briefly press alarm button and use SELECT knob to
cycle through Alarm 1 and Alarm 2.
Rotate and press th e SELE CT knob to adjust and set the hour and
minutes and press to move to the next setting.
Alarm Mode： Buzz/AM/FM
Volume: rotate the SELECT knob to set the required alarm volume
from 0 to 30.
5. SLEEP： with the DR2 playing AM/FM, you can set a period of
time before the radio enters 'standby' mode.
Note:
the
radio
must
be
active
and
not
in 'standby' mode
already.
To set the sleep timer, Briefly press SLEEP to cycle through the
sleep timer from 10 MINS, 20 MINS, 30 MINS, 40 MINS, 50 MINS, 60
MINS, 70 MINS, 80MINS, 90 MINS or Sleep OFF. Stop when the
required time is displayed, after a brief moment the screen returns to
the screen being used before the sleep function was selected.
To cancel a sleep time, select Sleep OFF from the sleep options.
Note: A sleep time is automatically cancelled if DR2 is put into
Standby.
. TUNE- / : Press to select the previous track under
AM/FM/Bluetooth mode; Press and hold the Tune- button 2 seconds
to auto-scan the stations under the AM/FM mode.
7.POWER (Turn ON/OFF/STANDBY ):
1)Push to power the DR2 On or Off (Standby).
2)When your DR2 is using power adapter, press POWER button to
switch 'on' and 'standby' .Unplug the power adapter to turn off your
DR2 completely.
3)When your DR2 is using batteries, press POWER button to switch
'on' and 'off'.
5 6
VOLUME +/VOLUME- button: Turn the Volume dial to increase or
decrease the volume. The volume knob may also be used to
navigate when in the station List.
8. PLAY& PAUSE/ : Press and hold this button to do auto scan
AM/FM stations and store the available stations to preset list
automatically.
In AM/FM mode, Press and hold “Play/Pause” button, it will
automatically scan for the available radio stations and store the
stations to preset list.
9. TUNE+ / : Press to select the next track under AM / FM/
Bluetooth Mode; Press and hold the Tune+ button 2 seconds to
auto-scan the stations under the AM/FM mode.
Bluetooth Operation
Streaming music and control from Smart device.
Prior to pairing, verify your device is not connected to any other
Bluetooth product. Devices may pair differently. Below is a general
guide
.
1. Press to Mode to Bluetooth mode. This will power on the
Bluetooth. Turn the volume up about ¼ to start. Also turn up the
volume on the smart device (the device you are streaming from).
2.
Turn on the Bluetooth on your enabled device.
3. Select Bluetooth device name “LEMEGA DR2” when it appears on
your device's screen to initiate searching.
4. You can start to play your music files wirelessly. Adjust the volume
level on your device.
You should not have to pair your device again.
Depending on your device, you may need to make multiple attempts
at Pairing and/or Connecting to the “LEMEGA DR2”, but please give
your device adequate time to Pair or Connect before repeating the
process.
To Next Page
Loading...
Need help?
General
