BLUETOOTH OPERATION
1.
Press the MODE button to switch to the Bluetooth mode.
2. The previous paired device will connect to speaker tower automatically when each
time changing to Bluetooth mode.
3. Turn on the Bluetooth device (e.g. phone) and enter the Bluetooth search interface.
4. Search "BTT-9" and pair it, input the password "0000" if necessary. If paired, the
display will blink steadily.
5.
If it still doesn't work, reset the Bluetooth and follow above steps again.
NFC OPERATION
1. Press the MODE button to enter the Bluetooth mode.
2. Place the back of phone (with NFC function) on the position of word “NFC” on the
front panel of the unit for 3 seconds, the Bluetooth function of the phone is activated
automatically.
3. When the indicator lights steadily and you can hear an audible signal, they are paired.
4. To disconnect NFC Bluetooth connection, place the back of the phone on the position
of the word “NFC” on the front panel of the unit. When there comes an audible
signal, they are disconnected.
5. Some devices of Android system 4.0 or below need to install the NFC.apk to enable
the NFC function. Some devices may be in a weak compatibility for NFC
function, that
may relate to the NFC software.
USB
USB OPERATION
1.
Power on the unit and insert a USB Flash Drive (not supplied) into the USB Port,
ensuring the plug is fully inserted at the correct way.
2. Press the MODE button to switch to the USB mode.
3. The tower will play music from the USB automatically.
4. The maximum size of Flash Drive that can be connected is 32GB max.
5. The supported format for USB play is MP3.
To Next Page
Loading...
Need help?
General
