8
FM radio
Selecting FM Stations
1. Short press the button on the device to turn on the radio.
2. Use the SKIP+ and SKIP - buttons to set the desired radio frequency. Or press the PRE button. repeatedly
to select a saved station(P01~P30).
Scanning Stations (manual)
1. Press SKIP+ and SKIP - buttons to adjust the display frequency in increments of 0.10 MHz.
Scanning Stations (automatic)
1. Press and hold SKIP+ and SKIP - buttons to start channel search.
• Search automatically starts and stops on the next station found.
• To continue searching, Press and hold the Prev or Next button again.
Storing FM stations
The device can store 30 FM stations (P01 to P30).
Station auto save (AMS)
1. CLK./MEM. Press down and hold still.
• The device initiates an automatic radio search and saves each station it finds to its own program location.
• When the station search is complete, the device jumps to the first program location (P01) and plays the
station stored there.
Manual save station
1. Set the desired radio frequency.
See also "Scanning Stations (manual)" or "Scanning stations (automatic)"
2. Press CLK./MEM button, the Pxx Blink on the display.
3. Use the SKIP+ and SKIP - buttons to select the desired storage location.
4. Press CLK./MEM button again to confirm the selection and complete the save.
Note: If there is already an existing FM station stored under a preset, it will be over written when you store
the new station.
Call the saved station
1. The PRE button. the Pxx shown on the display.
2. Press the SKIP+ or SKIP- button until the desired the Pxx on the display. Play stored stations.
3. Or directly press the PRE button repeatedly to select pre-storage stations P01~P30.
until the desired the Pxx on the display. Play stored stations.
Alarm setting
To set the alarm time, the device must be in standby mode.
1. Press and hold the VOL - /AL.1 button. • The currently set alarm time appears on the display.
The time will blink.
To Next Page
Loading...
