LENCO DVP-754 - Parameters and Specifications; Technical Parameters

3. SETUP Menu Setting
Preference Page
PAL - Select this if the connected TV is PAL system. It will change the video signal of a NTSC disc and
output in PAL format.
NTSC - Select this if the connected TV is NTSC system. It will change the video signal of a PAL disc and
output in NTSC format.
Auto: Chang the video signal output automatic according to the playing disk format.
Audio: Selects a language for audio (if available).
Subtitle: Selects a language for subtitle (if available).
Disc Menu: Selects a language for disc menu (if available).
Default: Back to the factory setting.
4. Parameters and specifications
Technical parameters
Item Standard requirement
Power requirements
: AC 100-240 V, 50/60 Hz
Power consumption
: <10W
Operating humidity
: 5% to 90%
Output
VIDEO OUT
: 1 Vp-p (75Ω)
AUDIO OUT
: 1.2 Vrms (1 KHz, 0dB)
Audio
: Speaker: 1Wx2, Headphones output
System
Laser
: Semiconductor laser, wavelength 650 nm
Signal system
: NTSC/PAL
Frequency response
: 20 Hz to 20 kHz (1 dB)
Signal-to-noise ratio
: More than 80 dB (ANALOG OUT connectors only)
Dynamic range
: More than 85 dB (DVD/CD)
Note: Design and specifications are subject to change prior notice.
14