LENCO L78 - Maintenance of Your Record Player; Mounting the Record Cleaning Device; Levelling the Turntable; Dust Cover Usage

The stylus should be kept clean of fluff and dust,
and
a
small
brush
is
recommended
for
this
pur-
pose.
N.B. It is important that brushing the stylus is done
only in one direction, from the rear edge of the
pick-up cartridge to the front, otherwise damage
might
occur
to
the
stylus
system.
Use
of
the
LENCOCLEAN Record Cleaning System however
will keep the stylus clean so that further cleaning
is not usually necessary.
At intervals of approximately one year the stylus
should be inspected under a microscope by a
technician. Worn or damaged stylus points cause
not
only
distorted
reproduction
but
also
unwanted
noises
and
serious
damage
to
your
records.
Mounting
the
Record
Cleaning
Device
LENCOCLEAN
The newly developed Record Cleaning System
LENCOCLEAN
has
been
specially
constructed
for
use
with
the
L78
and
provides
a
means
of
main-
taining your records in perfect condition and gua-
rantees optimum reproduction.
Remove
the
screw
in
the
left-hand
back
corner
and
in
its
place
screw
in
the
spindle
«C»
supplied
with the LENCOCLEAN. The exact mounting ins-
tructions are provided with each LENCOCLEAN.
c- | F x0
a
Fig.3
LENCOCLEAN with SUPER-TONIC
— for reproduction without extraneous noise
— for minimum wear on records and pick-up
needle
— for utterly simple care of records
LENCOCLEAN with SUPER-TONIC for the sake of
your records.
Levelling the Turntable
The L 78 is mounted on viscously damped springs.
In order to mount this precision instrument exactly
level the adjustable damping bushes have a slot in
them. By inserting a coin into the slot and turning,
the height of the springs can be altered. When the
unit
is
supplied
mounted
on
a
plinth,
then
an
opening
can
be
found
at
the
bottom
of
the
plinth
for this regulation.
Important
Before
tipping
the
unit
to
adjust
the
level,
it
is
imperative
that
the
turntable
is
removed.
However,
to
check
whether
the
unit
is
level
the
turntable
has to be replaced.
Dust Cover
The
L78
Hi-Fi
Transcription
Turntable
Unit
mounted
on
wooden
plinth
is
supplied
together
with
a
dust
cover.
This
can
be
fitted
to
the
holders
at
the
back
of
the
cabinet.
Thanks
to
a
special
construction
the
dust
cover
can
stay
open
in
every
position
down
to
20°,
after
which
it automatically
closes.
When placing the dust cover on to the wooden
plinth, care should be taken to ensure that both
hinges on the dust cover are folded back simul-
taneously,
otherwise
there
is
danger
that
the
mov-
able plastic part of the dust cover might break.