9
BLUETOOTH CONNECTION
- Once the power switch is turned to "On", Bluetooth "BT" mode is set as default
- Blue LED indicator will flash in pairing mode. The RED LED display will show "bt"
- Turn on the Bluetooth function on your device and search for "Lenco PA-90" then
press to connect.
- Connected sound signal will be heard and the
blue led connection indicator will stop blinking
and stay steady.
- Bluetooth connection is completed.
- Select the music from your Bluetooth device
and start playing.
- Hold the BT DISCONNECT (BT PAIR) key to
disconnect paired device and enter pairing
mode.
FM RADIO
- Press the "Source" Button and select Radio, the FM Radio Frequency will show on
the RED LED display.
- Hold play/pause key to auto search and store.
- Press and hold the TU or TU buttons for choosing the next stored available
station. Short press them to fine tune.
USB PORT
- Press the "Source" Button and select USB, USB will show on the RED LED display.
- Insert the USB stick.
- Select your favorate music by pressing
TU or TU .
- Press "REP" once to repeat the current
selected song.
- Press "REP" the 2
nd
time to repeat all
songs.
- Press "REP" the 3
rd
times to random
- Press "REP" again to turn repeat off.
If unit is playing on Bluetooth mode "BT and LINE", it will automatically
switch to USB mode once insert the USB stick.
Important: The USB port is intended for data transfer only; other devices cannot be
used with this USB connection. The use of USB extension cords is not
recommended
To Next Page
Loading...
Need help?
General
