LENCO SCD-720 - CD and USB Playback Operations; Loading and Starting Playback; Playback Control Functions; Repeat, Random, and Programmed Playback

-13-
Scan Setting
1. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
2. Press the or button until “Scan” is displayed and then press the ENTER button.
3. Press the or button to toggle between “Strong” and “All” and then press the ENTER button conrm. When the
“Strong” is selected, only the strong stations are detected. Scanning will ignore the noisy stations. When “All” is selected,
all stations will be detected during FM scanning even if the radio station is a bit noisy.
4. The next time doing a FM scan the unit will search for the stations based on this conrmed setting.
Audio Setting
1. Press and hold the MENU button (or press the MENU button on the remote control) to access the menu control.
2. Press the or button until “Audio” is displayed and then press the ENTER button.
3. Press the
or button to toggle between “Stereo” or “Mono” selection and then press the ENTER button conrm.
CD/USB OPERATION
Loading and Playing CD Disc
Open the CD door. Install a disc with the CD label side facing up. Close the CD door. Press the SOURCE button to CD mode.
After reading, the total number of tracks will be shown on the display and it will automatically start to play.
Reading and Playing USB Device
Insert a USB device into the USB input jack. Press the SOURCE button to USB mode. After reading the total number of tracks
will be shown on the display. It will automatically start to play.
Play/Pause Control
To pause playback press the button. Press the button again to resume playback.
Stop Control
To stop playback press the button.
Skip Track
During playback press the or button to skip to the previous or next track.
High Speed Music Search
During playback press  hold the or button to start high speed searching.
When you release the or button normal speed playback will resume.
Repeat Play / Random Play
CD Disc mode
During playback press the REPEAT button once, the display shows “REP.ONE”. The current track will be played repeatedly.
When pressing the REPEAT button again, the display shows “REP.ALL”. All tracks will be played repeatedly.
When pressing the REPEAT button again, the display shows “RANDOM”. All tracks will be played in random sequence.
When pressing the REPEAT button again, the unit will resume to normal playback.
MP3 Disc or MP3 USB mode
During playback press the REPEAT button once, the display shows “REP.ONE”. The current track will be played repeatedly.
When pressing the REPEAT button again, the display shows “REP.ALBUM”. All tracks in the current folder will be played
repeatedly.
When pressing the REPEAT button again, the display shows “REP.ALL”. All tracks will be played repeatedly.
When pressing the REPEAT button again, the display shows “RANDOM”. All tracks will be played in random sequence.
When pressing the REPEAT button again, the unit will resume to normal playback.
Programmed Playback
CD Disc mode
This unit can be programmed to play a sequence of tracks selected.
1. In stop mode press the PROGRAM button, the display shows the program number and the track number.
2. Press the or button to select the desired track.
3. Press the PROGRAM button to save the desired track.
4. Repeat steps 2-3 to store up to 30 programmed tracks.
5. Press the button to start playing the programmed tracks.
6. To clear the program play, press the button twice or change to another mode.
7. During program play you can also do the “Repeat One” or “Repeat All” operation, however the random play is not
supported.