FILE DELETE AT USB / SD CARD (BY REMOTE CONTROL)
THE SYSTEM IS ABLE TO ERASE THE FILE STORED INSIDE THE USB PEN DRIVE OR SD CARD BY
FOLLOWING:-
A) SINGLE FILE DELETE
1. PRESS AND HOLD THE “ INFO “ BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
2. PRESS SKIP FORWARD OR SKIP BACKWARD BUTTON TO SELECT THE FILE GOING TO
DELETE
3.
PRESS THE “ REC “ BUTTON TO ENTER “ YES / NO “ MODE AND THEN PRESS SKIP
FORWARD
OR SKIP BACKWARD TO SELECT “ YES “ OR “ NO “.
4. PRESS THE “ REC “ BUTTON AGAIN TO CONFIRM THE SETTING.
B) ALL FILE DELETE
1. PRESS AND HOLD THE “ INFO “ BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
2.
PRESS AND HOLD THE “ INFO “ BUTTON TO ENTER “ YES / NO “ MODE AND THEN PRESS SKIP
FORWARD
OR SKIP BACKWARD TO SELECT “ YES “ OR “ NO “.
3. PRESS THE “ REC “ BUTTON AGAIN TO CONFIRM THE SETTING.
REMARK : ALL THE FILES INSIDE THE USB STORAGE MEDIA OR SD CARD WILL BE DELETED
COMPLETELY AFTER CONFIRMING TO “ YES “ MODE.
TROUBLESHOOTING
-DISPLAY DOESN’T SHOW ANYTHING: PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
-DISPLAY DOESN’T SHOW ANYTHING
WHEN SWITCHING THE SOURCE
SELECTOR: PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
OPERATE THE SOURCE SELECTOR SWITCH CAREFULLY,
SWITCHING TO FAST OR SWITCHING MORE THEN ONE STEP
AT A TIME MAY RESULT IN A MALLFUNCTION AGAIN
-UNIT FREEZES COMPLETELY: PLEASE COMPLETELY REMOVE THE AC CORD FROM THE
WALL OUTLET AND WAIT AT LEAST 20 SECONDS BEFORE
PLUGGING IT IN AGAIN
IF AT ANY TIME IN THE FUTURE YOU SHOULD NEED TO DISPOSE OF THIS PRODUCT PLEASE
NOTE THAT: WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH
HOUSEHOLD WASTE. PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL
AUTHORITY OR RETAILER FOR RECYCLING ADVICE. (WASTE ELECTRICAL AND ELECTRONIC
EQUIPMENT DIRECTIVE)
GB-7
To Next Page
Loading...
Need help?
General
