EasyManua.ls Logo

Lennox AIRCOOLAIR KNCK 24E - Page 18

Lennox AIRCOOLAIR KNCK 24E
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17
Electrical
Box
Thermostat
connection
Nr OF CABLES X SECTION (mm
2
)
Nr OF CABLES X SECTION (mm
2
)
UNIT
MODEL
38E
32E
43E
24E
48D
76D
64D
86D
POWER SUPPLY
230V THREE-PHASE
UNITS
Power supply
WITH
electrical heater (*)
Indoor motor fan
electrical connection
UNIT
MODEL
38E
32E
43E
24E
48D
76D
64D
86D
POWER SUPPLY
400V THREE-PHASE
UNITS
Power supply
electrical heater (optional)
Power supply
WITHOUT
electrical heater (*)
Power supply
WITH
electrical heater (*)
Indoor motor fan
electrical connection
Power supply
electrical heater (optional)
Power supply
WITHOUT
electrical heater (*)
4 x 10
4 x 16
4 x 16
3 x 25 + 1 x 16
3 x 50 + 1 x 25
3 x 95 + 1 x 50
3 x 35 + 1 x 16
3 x 70+ 1 x 35
3 x 95 + 1 x 50
3 x 120 + 1 x 70
4 x 1,5
4 x 1,5
4 x 1,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 10 + 3 x 1,5
4 x 10 + 3 x 1,5
4 x 10 + 3 x 1,5
4 x 16 + 3 x 1,5
4 x 10 + 3 x 1,5
4 x 16 + 3 x 1,5
4 x 16 + 3 x 1,5
4 x 16 + 3 x 1,5
5 x 4
5 x 6
5 x 10
5 x 10
5 x 10
5 x 25
5 x 25
3 x 35 + 2 x 16
5 x 16
5 x 16
3 x 25 + 2 x 16
3 x 35 + 2 x 16
3 x 50 + 2 x 25
5 x 10
4 x 1,5
4 x 1,5
4 x 1,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 2,5
4 x 4 + 3 x 1,5
4 x 4 + 3 x 1,5
4 x 4 + 3 x 1,5
4 x 6 + 3 x 1,5
4 x 4 + 3 x 1,5
4 x 6 + 3 x 1,5
4 x 6 + 3 x 1,5
4 x 6 + 3 x 1,5
3 x 25 + 1 x 16
3 x 50 + 1 x 25
3 x 25 + 1 x 16
3 x 25 + 1 x 16
3 x 35 + 1 x 16
3 x 95 + 1 x 50
3 x 25 + 2 x 16
3 x 50 + 2 x 25
1 STAGE 2 STAGES
-------
-------
2 x (4 x 10) + 4 x 1,5
-------
2 x (4 x 10) + 4 x 1,5
2 x (4 x 10) + 4 x 1,5
2 x (4 x 10) + 4 x 1,5
-------
-------
-------
2 x (4 x 4) + 4 x 1,5
-------
2 x (4 x 4) + 4 x 1,5
2 x (4 x 4) + 4 x 1,5
2 x (4 x 4) + 4 x 1,5
-------
1 STAGE 2 STAGES
- Connect the power supply cables to the terminals in the electric box through the grommet.
- The sections have been calculated for a length no longer than 50m and a voltage drop of 10V.
Do not start the unit if the drop is greater than this.
- The wiring and circuit breakers to be mounted in the installation must comply with the Regulations in force.
- Ground wires must be properly connected and have a greater length than the phase wires.
(*) According to standards, you can use different sections for PE and N.
1
2
3
4
INDOOR
SECTION
OUTDOOR
SECTION
FOR UNIT MODELS:
24E-32E-38E-43E
48D-64D-76D-86D
2.- INSTALLATION
2.6.- ELECTRICAL CONNECTIONS
Power supply.
Indoor motor fan electrical connection.
Electrical heater connection (optional).
Terminal-Thermostat connection
(See electrical connection for the controller).
- BEFORE MAKING ANY ELECTRICAL CONNECTIONS, BE SURE THAT ALL CIRCUIT BREAKERS
ARE OPEN.
- IN ORDER TO CARRY OUT THE ELECTRICAL CONNECTIONS, FOLLOW THE ELECTRICAL DIAGRAM
SUPPLIED WITH THE UNIT.
1
23
4
11
2
3
PE L1 L2
X1
L3
3 ~ 230V - 50 Hz + PE
PE L1 L2 L3 N
X1
3N ~ 400V - 50 Hz + PE
11
2 3

Related product manuals