13
MODIFY PARAMETERS
NOTE: When the leds on the
display flash alternatively
from one to the other, you
are on menu mode.
It shows:
Inlet water temperature
Active alarms
mode
on off
Press
mode
on off
Press
mode
on off
Press
mode
on off
Press
Menu of configuration parameters of the unit.
To access to parameters modification, a password should be included to the system; this is not necessary if you only want to
see the parameters.
PARAMETERS
MAIN DISPLAY
Press
Press
Press
It shows:
Inlet water temperature
Active alarms
Press
Press
Press
PASSWORD
Press
Press
General configuration parameters of the unit (Values (H)).
Configuration parameters concerning to compressor (Values (C)).
Configuration parameters concerning to fan and defrost control (Values (F)).
Configuration parameters concerning to active alarms (Values (A)).
Configuration parameters concerning to water pump (Values (P)).
Configuration parameters concerning to anti-freeze (Values (r)).
Configuration parameters concerning to defrost cycle (Values (d)).
mode
on off
+
mode
on off
+
>2" <2"
Insert password
(number 38)