To Next PageTo Next Page
Need help?Do you have a question about the Lennox EL196UH110XE60C and is the answer not in the manual?
Critical safety warnings and cautions for handling and installation.
Lists the items included with the furnace shipment.
Outlines conditions for using the furnace as a temporary construction heater.
Details requirements for air supply in Non-Direct Vent installations.
Details furnace installation in the upflow position.
Provides guidelines for connecting the return air system.
Warns against installing the furnace on its front or back.
Details the process for installing the furnace on a platform.
Warns against drawing return air from rooms with gas appliances due to CO risk.
Guidance on using PVC primer, solvent cement, and ABS transition cement.
Warns about fume ignition during system checks.
Guidelines for using approved vent piping systems.
Warns against using screens in terminations to prevent freeze-ups.
Illustrates typical horizontal vent and intake pipe connections.
Diagram for upflow non-direct vent intake pipe connections.
Canadian-specific requirement for air intake and exhaust outlet separation.
Diagram for flush-mount side wall termination kit.
Information on venting through crawl spaces and extended horizontal runs.
Warns against using copper tubing or lines for condensate drains.
Illustrates furnace and coil with separate drains.
Importance of venting A/C condensate drains for furnace operation.
Procedure for checking gas piping for leaks.
Warning about CO poisoning from venting system issues.
Warning about electric shock hazard and proper grounding.
Information on adjusting indoor blower speeds.
Warning about operating flood-damaged furnace components.
Warning about fire or explosion if instructions are not followed.
How to check for proper combustion and CO levels.
Table detailing conversion kit and switch requirements for altitude.
How to check and adjust furnace temperature rise.
Checklist for annual furnace maintenance.
Steps for cleaning the burner assembly.
Specific venting requirements for Ontario.
Manufacturer requirements when providing vent system components.
Checks related to gas supply connection and pressure.
Verify thermostat settings and owner explanation.
Warning about fire and explosion hazards from failure to follow safety warnings.
Information for homeowners about safety devices and periodic checks.
Warning about CO poisoning from combustion product infiltration.
Warning about fire or explosion if instructions are not followed.
Warning about asphyxiation hazard from venting system issues.
Annual furnace maintenance schedule and items.
Procedures for performing a general system test.
Description of the temperature indicator on the thermostat's home screen.
How to select the operating mode (heat/cool, fan).
How to select and configure fan operation modes.
How system errors or reminders are displayed.
Setting and managing predefined and custom reminders.
Enabling/disabling screen saver and adjusting backlight settings.
Important note to read the manual before programming the thermostat.
Caution regarding installing the thermostat on voltages higher than 30VAC.
Steps for unpacking and selecting a location for the thermostat.
Steps for installing the thermostat without a wall plate.
Explains the function of each terminal on the thermostat.
Lists available installer settings options.
Setting the minimum difference between cooling and heating setpoints.
Setting energy-saving temperature points for heating and cooling.
Information about managing reminders.
General