VIII-FACTORY-INSTALLED Hot Gas Re-Heat
General
-
L14 and L30 Reheat Coil Solenoid Valves
Reheat Setpoint
Settings
- Control
-
A91 Humidity Sensor
-
TABLE 22
+
Check-Out
-
1 -
section.
2 -
-
Compressor 1 and 2 (reheat) should de-energize, blower
should still be energized.
Default Reheat Operation
-
1 -
IMPORTANT - Free cooling does not operate during
reheat.
-
Additional Cooling Stages
NOTE - Another thermostat staging option is available
which allows both compressors to be energized during
free cooling. See Unit Controller manual for details.
To Next Page
Loading...
