GUIDE SPECIFICATIONS
T−Class Packaged Gas / Electric 7.5 to 12.5 tons / Page 9
D. Quality Assurance:
1. Test Reports: Certified test reports showing compliance with specified performance characteristics and physical
properties.
2. Certificates: Product certificates signed by manufacturer certifying materials comply with specified performance
characteristics and criteria and physical requirements.
3. Manufacturer’s Instructions: Manufacturer’s installation instructions.
Specifier Note: Coordinate paragraph below with Part 3 Field Quality Requirements Article herein. Retain or delete as
applicable.
E. Manufacturer’s Field Reports: Manufacturer’s field reports specified herein.
F. Closeout Submittals: Submit the following:
1. Warranty: Warranty documents specified herein.
2. Operation and Maintenance Data: Operation and maintenance data for installed products in accordance with
Division 1 Closeout Submittals (Maintenance Data and Operation Data) Section. Include methods for maintaining
installed products and precautions against cleaning materials and methods detrimental to finishes and
performance. Include names and addresses of spare part suppliers.
3. Provide brief description of unit, with details of function, operation, control and component service.
4. Commissioning Report: Submit commissioning reports, report forms and schematics in accordance with Section
01810 − Commissioning.
1.05 QUALITY ASSURANCE
A. Qualifications:
1. Installer experienced in performing work of this section who has specialized in installation of work similar to that
required for this project.
1.06 DELIVERY, STORAGE & HANDLING
A. General: Comply with Division 1 Product Requirements.
B. Ordering: Comply with manufacturer’s ordering instructions and lead−time requirements to avoid construction delays.
C. Packing, Shipping, Handling and Delivery:
1. Deliver materials in manufacturer’s original, unopened, undamaged containers with identification labels intact.
2. Ship, handle and unload units according to manufacturer’s instructions.
D. Storage and Protection:
1. Store materials protected from exposure to harmful weather conditions.
2. Factory shipping covers to remain in place until installation.
Specifier Note: Coordinate article below with Conditions of the Contract and Division 1 Closeout Submittals (Warranty).
1.07 WARRANTY
A. Project Warranty: Refer to Conditions of the Contract for project warranty provisions.
B. Manufacturer’s Warranty: Submit, for Owner’s acceptance, manufacturer’s standard warranty document executed by
authorized company official. Manufacturer’s warranty is in addition to, and not a limitation of, other rights Owner may have
under Contract Documents.
Specifier Note: Coordinate paragraph below with manufacturer’s warranty requirements.
C. Warranty: Commencing on Date of Installation.
Specifier Note: Refer to Lennox Equipment Limited Warranty certificate included with equipment for details.
1. Heat Exchanger:
a. Aluminized Steel: 10 years, limited (non−residential applications)
b. Stainless Steel: 15 years, limited (non−residential applications)
2. Solid−State Ignition Module: 1 year, limited (non−residential applications)
3. All other components: 1 year limited
To Next Page
Loading...
Need help?
General
