Lennox VEMD007N432U - Standard Fittings; Location for Installation

Multi Variable Air Conditioners Duct Type Indoor Unit
5
4.1 Standard Fittings
Please use the supplied standard fittings listed below as instructed.
No. Name Graphics Quantity Purpose
1
wire controller package
(including wire controller,
emergency bottom case,
instruction manual, screws,
packing box)
1set
Control indoor unit
2 Remote controller
0 or 1
optional parts
(including #7
batteries)
3 Sponge for drainage pipe
2
wrap water pipe and
rubber cork for
condenser
4 Insulating materials
2
used for the joint of
gas pipe and liquid
pipe for indoor unit
5 Corrugated pipe
0 or 1
Diameter of air
pipe≥15.9mm
6 Union nut
1 or 2
one for the model with
corrugated pipe; two
for other models
7
Spring washer M8, nut M8,
nut with washer M8, washer
M8
4
Used for hanging the
indoor unit
8 Tieline
6
Wrap the sponge at
the connection
position
9 others
User Manual: 1 copy
Loosen-leaf of Instruction Manual: 1 copy (harmful substance content table)
Qualified Certificate: 1 copy
Bar Code : 1 copy
4.2 Location for Installation
(1) The top holder must be strong enough to support unit's weight.
(2) Drain pipe can drain water out easily.
(3) There is no obstacle at inlet or outlet. Please ensure good air circulation.
(4) In order to make sure the space for maintenance, please install the indoor unit according to
the dimension described below.
(5) Keep the unit away from heating source, inflammable gas or smoke.
(6) This is a concealed ceiling type unit.
(7) Indoor unit, outdoor unit, power cord and electric wire should stay at least 1m from the TV
set and radio. Otherwise, these electrical appliances may have image interference and
noise (Even if the distance is 1m, when there is strong electric wave, noise may still occur).
(8) The appliance shall not be installed in the laundry.