DC Inverter Multi VRF System
29
U2
Wrong setting of ODU’s capacity
C5
Alarm because project code of IDU is
Refrigerant-lacking protection
Emergency status of compressor
U5
Wrong address for driving board of
C9 Emergency status of fan
Alarm because valve is abnormal
Rated capacity is too high
Malfunction of pipeline for IDU
Malfunction of lack of main control unit
Malfunction of pipeline for ODU
Rated capacity is too low
UC Setting of main IDU is successful CF
Malfunction of multiple main control
UL Wrong button-dial CJ
Address DIP switch code of system is
Charging of refrigerant is invalid
Malfunction of multiple wired controller
C0
Communication malfunction between
IDU, ODU and IDU’s wired controller
CU
Communication malfunction between
IDU and the receiving lamp plate
C2
Communication malfunction between
main control and inverter compressor
Cb Overflow distribution of IP address
C3
Communication malfunction between
main control and inverter fan driver
Status:
A0 Unit waiting for debugging AP
Debugging confirmation when starting
A1
Inquiry of compressor operation
AU Long-distance emergency stop
A2
Refrigerant recovery operation of
after-sales
Ab Emergency stop of operation
SE operation setting of system
Heat pump function setting
Setting of defrosting cycle K1
A7 Quiet mode setting n2
Setting of upper limit of IDU/ODU
capacity distribution ratio
A8 Vacuum pump mode n4
Limit setting for max. capacity/output
EU AA level EER test mode
Inquiry of project code of IDU
Charge refrigerant automatically
Charge refrigerant manually
Cleaning reminding of filter
8 Maintenance and Care
Regular check, maintenance and care can extend unit’s service life. Please have specialized
person in charge of the management of air conditioners.
8.1 Outdoor Heat Exchanger
Outdoor heat exchanger shall be cleaned regularly, which is at least once every two months. You
can use a dust catcher with nylon brush to clean away the dust on the heat exchanger. If compressed