What to do if the Lenovo ThinkCentre M75e does not start when pressing the power switch?
First, ensure the power cord is correctly connected to both the rear of the Lenovo Desktop and a working electrical outlet. Next, check that the power indicator on the front of the computer is lit. Finally, confirm that the computer voltage matches the voltage available at the electrical outlet in your region.
What to do if the keyboard does not work on Lenovo Desktop?
First, verify that the Lenovo Desktop is turned on. Then, ensure the keyboard is correctly connected to the appropriate keyboard connector (either the PS/2 or USB connector) on the computer. Also, check that no keys are stuck.
Why is the monitor screen blank on my Lenovo Desktop?
Check that the monitor signal cable is correctly connected to both the monitor and the appropriate connector on the Lenovo Desktop. If a PCI graphics card is installed, use the connector on the graphics card. Also, verify the monitor power cord is correctly connected to the monitor and a working outlet. Ensure the monitor is turned on and the brightness and contrast are properly set. Finally, confirm the computer voltage matches the outlet voltage.
What to do if the mouse does not work on Lenovo ThinkCentre M75e Desktop?
First, check that the Lenovo Desktop is turned on. Then, ensure the mouse is correctly connected to the appropriate mouse connector (either the PS/2 or USB connector) on the computer. Finally, make sure the mouse is clean.
Covers static-sensitive device handling, general installation, and external options.
Procedures for removing the cover, accessing internal parts, and replacing key components.
Steps to create and use recovery media for data backup and system restoration.
How to perform backup and recovery operations using Rescue and Recovery.
How to use the Rescue and Recovery workspace for system recovery.
Instructions on how to launch the system's Setup Utility program.
How to view and modify system configuration settings within the utility.
Procedure to recover the system after a failed POST or BIOS update.
To Next Page
General