• FQXSPPP4048I: Attempting to AC power cycle server [arg1] by user [arg2].
AC power cycle server
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0227
User Action:
Information only; no action is required
• FQXSPPP4049I: Management Controller [arg1] reset was initiated by Front Panel.
Management Controller reset was initiated by Front Panel
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0252
User Action:
Information only; no action is required
• FQXSPPR0000I: [ManagedElementName] detected as present.
This message is for the use case when an implementation has detected a Managed Element is now
Present.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0390
User Action:
Information only; no action is required
• FQXSPPR2001I: [ManagedElementName] detected as absent.
This message is for the use case when an implementation has detected a Managed Element is Absent.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID:
CIM Prefix: PLAT CIM ID: 0392
User Action:
Information only; no action is required
• FQXSPPU0001N: An Over-Temperature Condition has been detected on [ProcessorElementName].
Chapter 3. XClarity Controller events 109
To Next Page
