EasyManua.ls Logo

Lenovo ThinkSystem D2 - Page 17

Lenovo ThinkSystem D2
226 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Install the PSU with higher capacity
080701CB: PSU_FFS: Power Supply, transition to Non-Critical from OK was asserted.
All power supply fans run at full speed.
Severity: Warning
User Action:
1. Ensure the room temperature remains at the required level.
2. Ensure all fan modules are installed and operating properly.
080701D8: PS_EPOW_OUT: Power Supply, transition to Non-Critical from OK was asserted.
Node is notified of PSU AC lost condition. Node could enter power throttling state and performance could
be affected.
Severity: Warning
User Action:
1. Check power supply LEDs
If AC LED is not lit, check power cord and input voltage.
If DC LED is not lit, remove and reinstall power supply.
If error LED is lit, replace the power supply.
2. If fault recurs, please call service.
080701D9: PS_THROTTLE_OUT: Power Supply, transition to Non-Critical from OK was asserted.
Node is notified of PSU Over-current condition. Node could enter power throttling state and performance
could be affected.
Severity: Warning
User Action:
1. Check power supply LEDs
If AC LED is not lit, check power cord and input voltage.
If DC LED is not lit, remove and reinstall power supply.
If error LED is lit, replace the power supply.
2. If fault recurs, please call service.
080701E8: PS1_THROTTLE: Power Supply, transition to Non-Critical from OK was asserted.
The power supply needs to lower its power consumption or risk being shut down due to a power supply
overcurrent or overtemperature condition
Severity: Warning
User Action:
1. Check power supply LEDs
If AC LED is not lit, check power cord and input voltage.
If DC LED is not lit, remove and reinstall power supply.
If error LED is lit, replace the power supply.
2. If fault recurs, please call service.
080701E9: PS2_THROTTLE: Power Supply, transition to Non-Critical from OK was asserted.
The power supply needs to lower its power consumption or risk being shut down due to a power supply
overcurrent or overtemperature condition
Severity: Warning
User Action:
Chapter 2. SMM2 events 13

Related product manuals