• FQXSPMA2012I: An Over-Temperature Condition has been removed on the
[PhysicalMemoryElementName] on Subsystem [MemoryElementName].
This message is for the use case when an implementation has detected an Over Temperature Condition
for Memory that has been Removed.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Temperature
SNMP Trap ID: 0
CIM Prefix: PLAT CIM ID: 0147
User Action:
Information only; no action is required
• FQXSPMA2013I: The System [ComputerSystemElementName] has detected a POST Error
deassertion.
This message is for the use case when an implementation has detected that Post Error has deasserted.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Memory
SNMP Trap ID: 41
CIM Prefix: PLAT CIM ID: 0185
User Action:
Information only; no action is required
• FQXSPNM4000I: Management Controller [arg1] Network Initialization Complete.
This message is for the use case where a Management Controller network has completed initialization.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - IMM Network event
SNMP Trap ID: 37
CIM Prefix: IMM CIM ID: 0001
User Action:
Information only; no action is required
• FQXSPNM4001I: Ethernet Data Rate modified from [arg1] to [arg2] by user [arg3].
This message is for the use case where a user modifies the Ethernet Port data rate.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0003
User Action:
Information only; no action is required
80
ThinkSystem D2 Enclosure, Modular Enclosure, Modular Enclosure for 6U Configuration and ThinkSystem SD530 Compute Node
Messages and Codes Reference
To Next Page
