• FQXSPNM4002I: Ethernet Duplex setting modified from [arg1] to [arg2] by user [arg3].
This message is for the use case where A user modifies the Ethernet Port duplex setting.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0004
User Action:
Information only; no action is required
• FQXSPNM4003I: Ethernet MTU setting modified from [arg1] to [arg2] by user [arg3].
This message is for the use case where a user modifies the Ethernet Port MTU setting.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0005
User Action:
Information only; no action is required
• FQXSPNM4004I: Ethernet locally administered MAC address modified from [arg1] to [arg2] by user
[arg3].
This message is for the use case where a user modifies the Ethernet Port MAC address setting.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0006
User Action:
Information only; no action is required
• FQXSPNM4005I: Ethernet interface [arg1] by user [arg2].
This message is for the use case where a user enables or disabled the ethernet interface.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: none
SNMP Trap ID:
CIM Prefix: IMM CIM ID: 0007
User Action:
Information only; no action is required
• FQXSPNM4006I: Hostname set to [arg1] by user [arg2].
Chapter 3. XClarity Controller events 81
To Next Page
