• FQXSPPW2104I: Non-redundant:Sufficient Resources from Redundancy Degraded or Fully
Redundant for [RedundancySetElementName] has deasserted.
This message is for the use case when a Redundancy Set has transitioned from Non-redundant:Sufficient
Resources.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Redundant Power Supply
SNMP Trap ID: 10
CIM Prefix: PLAT CIM ID: 0807
User Action:
Information only; no action is required.
• FQXSPPW2110I: Non-redundant:Insufficient Resources for [RedundancySetElementName] has
deasserted.
This message is for the use case when a Redundancy Set has transitioned from Non-redundant:
Insufficient Resources.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: Critical - Redundant Power Supply
SNMP Trap ID: 9
CIM Prefix: PLAT CIM ID: 0811
User Action:
Information only; no action is required.
• FQXSPPW4001I: PCIe Power Brake for [arg1] has been [arg2].
This message is for the use case where PCIe Power Brake.
Severity: Info
Serviceable: No
Automatically notify Support: No
Alert Category: System - Other
SNMP Trap ID: 22
CIM Prefix: IMM CIM ID: 0243
User Action:
Check if system have fan fail error, Raidlink CEM fail occurring or Ambient temperature over 35C,
implement the "error" service action to recovery the system and reduce ambient temperature under 35C.
• FQXSPPW4002I: Total graphics power value has exceeded the pre-configured limit.
This message is for the use case where total graphics power value value has exceeded the pre-configured
limit.
Severity: Warning
Serviceable: No
Automatically notify Support: No
Alert Category: Warning - Other
SNMP Trap ID: 60
CIM Prefix: IMM CIM ID: 0328
Chapter 2. XClarity Controller events 113
To Next Page
Loading...
