• FQXSFPU4053G: System TPM_POLICY does not match the planar.
Severity: Warning
User Action:
Complete the following steps:
1. Remove any newly added TPM card from the planar or re-install the original TPM card that shipped
with the system.
2. Reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4054G: TPM card logical binding has failed.
Severity: Warning
User Action:
Complete the following steps:
1. Reboot the system.
2. If the problem persists, collect Service Data logs and contact Lenovo Support.
• FQXSFPU4056M: TPM card is changed, need install back the original TPM card which shipped with
the system.
Severity: Error
User Action:
Complete the following steps:
1. Re-install the original TPM card that shipped with the system.
2. Reboot the system.
3. If the problem persists, collect Service Data logs and contact Lenovo Support.
Note: The solution for this error may involve a system board replacement. If TPM encryption has
been enabled, back up TPM Encryption Recovery Key.
• FQXSFPU4059I: User requested to skip freezing lock of AHCI-attached SATA drives. System UEFI
accepted the request and will execute prior to OS boot.
Severity: Info
User Action:
Complete the following steps:
1. Change SystemOobCustom.SkipAhciFreezeLock from Disable to Enable using OneCLI tool.(use
OneCLI command “OneCli config set SystemOobCustom.SkipAhciFreezeLock “Enabled” --imm
IMM_USERID:IMM_PASSWORD@IMM_IP --override”).
2. Reboot the system into OS.
• FQXSFPU4060I: Skipped freezing lock of AHCI-attached SATA drives.
Severity: Info
User Action:
Information only; no action is required.
• FQXSFPU4061I: Restored default locking behavior of AHCI-attached SATA drives.
Severity: Info
Chapter 3. UEFI events 189
To Next Page
Loading...
