Table 2. Events organized by severity (continued)
Event ID
Message String Severity
FQXSPBR4008I Management Controller [arg1]: Configuration restoration from a file by
user [arg2] failed to start.
Error
FQXSPCA0002M Numeric sensor [NumericSensorElementName] going low (lower
critical) has asserted.
Error
FQXSPCA0009M Numeric sensor [NumericSensorElementName] going high (upper
critical) has asserted.
Error
FQXSPCA0011N Numeric sensor [NumericSensorElementName] going high (upper
non-recoverable) has asserted.
Error
FQXSPCA0017M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPCA0019N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPCR0001N Sensor [SensorElementName] has transitioned to non-recoverable
from a less severe state.
Error
FQXSPEA0002M Sensor [SensorElementName] has transitioned to critical from a less
severe state.
Error
FQXSPFW0000N The System [ComputerSystemElementName] encountered a POST
Error.
Error
FQXSPFW0001N Firmware BIOS (ROM) corruption was detected on system
[ComputerSystemElementName] during POST.
Error
FQXSPFW0002N The System [ComputerSystemElementName] encountered a firmware
hang.
Error
FQXSPIO0001L The connector [PhysicalConnectorElementName] has encountered a
configuration error.
Error
FQXSPIO0003N
A diagnostic interrupt has occurred on system
[ComputerSystemElementName].
Error
FQXSPIO0004L A bus timeout has occurred on bus [SensorElementName].
Error
FQXSPIO0006N A software NMI has occurred on system
[ComputerSystemElementName].
Error
FQXSPIO0007N A PCI PERR has occurred on system
[ComputerSystemElementName].
Error
FQXSPIO0008N A PCI SERR has occurred on system
[ComputerSystemElementName].
Error
FQXSPIO0011N An Uncorrectable Error has occurred on [SensorElementName].
Error
FQXSPIO0013N A Fatal Bus Error has occurred on bus [SensorElementName].
Error
FQXSPIO0015M Fault in slot [PhysicalConnectorSystemElementName] on system
[ComputerSystemElementName].
Error
FQXSPMA0002N Configuration Error for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
Error
FQXSPMA0005N Subsystem [MemoryElementName] has insufficient memory for
operation.
Error
FQXSPMA0007L Scrub Failure for [PhysicalMemoryElementName] on Subsystem
[MemoryElementName].
Error
22 ThinkSystem ST650 V2 Messages and Codes Reference
To Next Page
Loading...
