Lenovo ThinkSystem SR250 V2 User Manual

ThinkSystem SR250 V2
Type 7D7Q and 7D7R
Quick Start
Your shipping box contains the following items:
⚫ SR250 V2
⚫ Material box, including printed documentation
If any item is missing or damaged, contact your place of purchase.
Ensure that you retain your proof of purchase and packing material.
They might be required to receive warranty service.
First glance
Server front view:
• Four 3.5-inch drives model
VGA connector (optional)
Front operator panel
USB 2.0 connector
Four 3.5-inch drive bays
(0-3)
USB 3.2 Gen 1 connector
Rack release latches
• Ten 2.5-inch hot-swap drives model
USB 2.0 connector
VGA connector (optional)
USB 3.2 Gen 1 connector
Ten 2.5-inch hot-swap drive
bays (0-9)
Front operator panel
Rack release latches
Server rear view:
• Fixed power supply model
PCIe slot 1
Ethernet connector 1
(shared with XCC network
port)
PCIe slot 2
Dedicated XClarity
Controller (XCC) network
connector
Power connector
VGA connector
USB 3.2 Gen 2 connectors
Serial connector
Ethernet connector 2
Note 1: For the rear view of the redundant power supply model, there
are two power connectors on your server.
Note 2: Depending on the configuration, the illustrations above might
differ slightly from your server.
Setting up the System
1. Install the required server components.
2. Install the server into the rack.
See the Rack Installation Guide provided with the rail kit.
3. Connect the cables.
4. Connect the management controller to the network.
5. Power on the server.
6. Configure the system.
For detailed information about installing hardware options and
configuring the system, see the following website:
http://thinksystem.lenovofiles.com/help/topic/sr250-
v2/introduction.html

Lenovo ThinkSystem SR250 V2 Specifications

General

Operating Systems Supported	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi
Processor	Intel Xeon E-2300 series, Intel Pentium, Intel Core i3
Memory	Up to 128GB DDR4 ECC UDIMM
Storage	Up to 4 x 3.5" or 4 x 2.5" HDD/SSD
Form Factor	1U Rack
Network Interface	1GbE or 10GbE
Drive Bays	Up to 4x 3.5" or 2.5" hot-swap or simple-swap drive bays
RAID Support	Software RAID, Hardware RAID (optional)
Expansion Slots	1 x PCIe 4.0 x16