CONNECTING THE BATTERY:
● The battery will need to be connected as a step in the assembly process, before charging and
before use of the ride-on.
● Remove the black plastic protective cover.
● Connect the red wire from the ride-on body onto the red terminal of the battery. Also ensure the
black wire is connected onto the black terminal of the battery.
Note: Pay attention to the positive and negative positions on the battery to prevent a short circuit.
BATTERY CAUTIONS:
If the ride-on will not be used for a long period of time (3 months or longer), it is advised that you
fully charge the battery and disconnect it from the connections.
A long period of non-use will damage the battery. It is advised that the battery should be charged
once a month, even if the ride-on is not being used.
A new battery must be fully charged before its first use.
Please take care with the battery as it contains acid electrolyte. Handling of the battery by adults
only.
If the battery has leaked, do not touch the acid. Place the battery into a polybag and dispose of it.
If the electrolyte splashes on your skin or into your eyes, immediately wash with water for at least
15 minutes and consult your doctor.
Do not contact the batteries two terminals with any other metal objects.
It will cause short circuiting, damage or fire.
Do not plug the charger into any non‐working or faulty wall socket. This could cause short circuiting
or fire.
CAUTIONS FOR CHARGING:
The ride-on is equipped with a charge protection function. Ensure that the power switch on the
ride-on is in the OFF position before charging.
When charging the ride-on, all the functions of the ride-on are not operational.
1. The charging time is 8 – 12 hours. Avoid intermittent charging as that can affect the battery life.
2. When charging, connect the chargers pin to the charging socket of the ride-on and plug the
charger into a 240v power point.
3. During the charging process, the heating of the charger or battery is normal (below 60 degrees
Celsius).
4. A new battery must be fully charged before its first use.
5. Ensure the charger is removed from the charging socket before the ride-on is used.
To Next Page
Loading...