7
STARTING THE LENTEK ELITE MOSQUITO TRAP
Step 1:
Open the gas valve on the tank to the full open position by turning it counterclockwise until the knob
stops rotating
Step 2:
Press and hold the safety button. While looking into the center of the burner unit through the window,
press and hold the black Ignitor button until a blue flame appears inside the window directly in front of
you.
WARNING If the unit does not light within approximately 10 seconds, then release the gas button and
wait at least 60 seconds for any built up gas to dissipate before attempting to relight.
Note: When installing a new or refilled propane tank, it may take up to 30 seconds for the gas to reach
the burner.
Step 3. Continue to hold the safety button in for 30 additional seconds after the initial ignition. Then
release safety button.
Step 4. Wait 60 seconds between lighting attempts to allow unburnt gas to escape. Repeat steps 2 and 3 if
the burner goes out. There is a safety device that must warm up enough to allow gas to the burner after
the safety button is released (No longer pushed in)
To Next Page
