8
OPERATION
1. Plug in the adapter’s power cord to an approved "Outdoor Use" extension cord and in accordance with
the safety instructions on page 12.
2. Plug the adapter end into the socket on the underside of the trap body as shown.
3. Locate the ON/OFF switch on the side of the main body. This activates the heater and the vacuum fan.
Turn it to the "ON" position.
4. Leave the
Lentek Elite Mosquito Trap turned on and the burner lit. The Lentek Elite Mosquito
Trap will operate for 4 to 6 weeks continuously capturing mosquitoes on a single tank of propane.
MAINTENANCE
1. Check the capture cup on a regular basis depending on how many mosquitoes are being trapped. Start
by checking the trap once a week and adjust according to the catch. Use only clean water to rinse the
cup, do not use any chemical or soap as the fragrance may repel mosquitoes from the trap. In many
cases, the large amount of airflow through the cup, grinds captured mosquitoes against the metal
mesh, breaking them into small pieces, which are then blown through the screen.
2. Refill the propane tank, as necessary when using continuously. Turn off the unit and disconnect the
electrical supply before changing the tank.
3. There is a replaceable fuse located on the bottom of the trap body. Check this fuse if the
Lentek Elite
Mosquito Trap does not turn on when properly plugged into the approved 120V AC electric adapter.
Replacement fuse is 250V / 2Amp).
4. Keep the area around the
Lentek Elite Mosquito Trap clear and free from combustible materials,
gasoline, and any other flammable vapours and liquids.
To Next Page
Loading...